Interior Light

Engine Switch Illumination Circuit

~2min read

DESCRIPTION

The lighting-on-approach system controls the engine switch illumination.

WIRING DIAGRAM

PRECAUTION / NOTICE / HINT

NOTICE:

Before replacing the certification ECU (smart key ECU assy), refer to the Registration chapter.

Click here

PROCEDURE

  1. PERFORM ACTIVE TEST USING TECHSTREAM

(a) Connect the Techstream to the DLC3.

(b) Turn the engine switch to ON (IG).

(c) Turn on the Techstream.

(d) Select the following menu items: Body Electrical / Smart Key / Active Test.

(e) Perform the Active Test by following the Techstream instructions.

Body Electrical > Smart Key > Active Test

Tester display

Item

Control Range

Diagnostic Note

Power/Engine SW Light

Engine switch illumination

OFF or ON

When performing the Active Test, make sure the following condition is met:

The engine switch illumination is in the OFF state (at least 15 seconds have elapsed since the switch changed from ON to OFF) and the engine switch is in the ON (ACC) or ON (IG) position, or the engine is running.

Body Electrical > Smart Key > Active Test

Power/Engine SW Light

OK:

The engine switch illumination turns on.

OK

GO TO APPLICABLE SYSTEM AS INDICATED IN THE PROBLEM SYMPTOMS TABLE

NG
  1. INSPECT ENGINE SWITCH

(a) Remove the engine switch.

Click here

(b) Inspect the engine switch.

Click here

OK:

The engine switch illumination operates normally.

NG

REPLACE ENGINE SWITCH

OK
  1. CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) - ENGINE SWITCH)

(a) Disconnect the F1 connector from the certification ECU (smart key ECU assembly).

(b) Measure the resistance according to the value(s) in the table below.

Standard resistance:

Tester Connection

Condition

Specified Condition

F59-9 (SWIL) - F1-10 (SWIL)

Always

Below 1 Ω

F59-6 (AGND) - F1-11 (AGND)

Always

Below 1 Ω

F59-9 (SWIL) or F1-10 (SWIL) - Body ground

Always

10 kΩ minimum

F59-6 (AGND) or F1-11 (AGND) - Body ground

Always

10 kΩ minimum

OK

REPLACE CERTIFICATION ECU (SMART KEY ECU ASSY)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR