Interior Light

ACC signal circuit

~3min read

DESCRIPTION

This circuit detects the ignition switch ACC or OFF position and sends this information to the Main Body ECU (Multiplex Network Body ECU).

WIRING DIAGRAM

PRECAUTION / NOTICE / HINT

NOTICE:

  • Check the fuses for the circuits related to this system before performing the following procedure.
  • Before replacing the main body ECU (multiplex network body ECU), refer to the registration section*1.

    Click here

    • *1: with Smart Key System

PROCEDURE

  1. CHECK DTC (SMART KEY SYSTEM (for Start Function))

HINT:

If the vehicle is not equipped with a smart key system, go to the next step (A).

(a) Clear the DTCs.

Click here

Body Electrical > Power Source Control > Clear DTCs

(b) Check for DTCs.

Click here

Body Electrical > Power Source Control > Trouble Codes

Result:

Result

Proceed to

No DTCs related to the smart key system (for start function) are output.

A

DTCs for the smart key system (for start function) are output.

B

B

GO TO SMART KEY SYSTEM (for start function)

A
  1. CHECK VALUE USING TECHSTREAM

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch to ON.

(c) Turn on the Techstream.

(d) Select the following menus: Body Electrical / Main Body / Data List.

(e) Read the Data List by following the instructions on the Techstream.

Body Electrical > Main Body > Data List

Tester display

Item

Range

Normal Condition

Diagnostic Note

ACC SW

Ignition Switch ACC Position Signal

ON or OFF

ON: Ignition switch in ACC position.

OFF: Ignition switch in OFF position

-

Body Electrical > Main Body > Data List

ACC SW

OK:

The normal conditions listed above are displayed.

OK

GO TO APPLICABLE SYSTEM AS INDICATED IN THE PROBLEM SYMPTOMS TABLE

NG
  1. CHECK HARNESS AND CONNECTOR (BATTERY POWER SOURCE)

(a) Disconnect connector 3K from the instrument panel junction block assembly.

(b) Measure the voltage according to the value(s) in the table below.

Standard voltage:

Tester Connection

Condition

Specified Condition

3K-1 - Body Ground

Always

11 à 14 V

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

OK
  1. INSPECT INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY

(a) Remove the instrument panel junction block assembly.

Click here

(b) Remove the main body ECU (multiplex network body ECU) from the instrument panel junction block assembly.

Click here

(c) Measure the resistance according to the value(s) in the table below.

*a

Component without wire harness connected

(instrument panel junction block assembly)

-

-

Standard resistance:

Tester Connection

Condition

Specified Condition

3K-1 - MB-30 (ACC)

Battery disconnected from 3A-30 and 3D-3

10 kΩ minimum

3K-1 - MB-30 (ACC)

Battery positive (+) → 3A-30

Battery negative (-) → 3D-3

Below 1 Ω

OK

REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)

NG

REPLACE INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY