Driving

Cruise control

7steps
~42min
2/5difficulty
Done 0 of 7

Function Overview

Use cruise control to maintain a set speed without operating the accelerator pedal.

  1. Indicators
  2. Set speed (color display only)
  3. Cruise control switch
    Toyota CH-R. Utilisation des systèmes d'aide à la conduite

Setting the vehicle speed

1. Press the "ON-OFF" button to turn on the cruise control.

The cruise control indicator is displayed on the multi-information display.

Press the button again to turn off the cruise control.

Toyota CH-R. Utilisation des systèmes d'aide à la conduite

2. Accelerate or decelerate the vehicle to the desired speed (above approximately 40 km/h [25 mph]) using the accelerator pedal, then push the stalk down to set the speed.

The cruise control "SET" indicator and the set speed (color display only) are displayed on the multi-information display.

The speed at which the vehicle is travelling when you release the stalk becomes the set speed.

Toyota CH-R. Utilisation des systèmes d'aide à la conduite

Setting the Set Speed

To change the set speed, push the lever down or up until the desired speed is reached.

  1. Increasing the speed
  2. To decrease the speed

Fine adjustment: Tap the control lever in the desired direction.

Major adjustment: Push and hold the lever in the desired direction.

Toyota CH-R. Utilisation des systèmes d'aide à la conduite

The set speed is increased or decreased as follows:

Fine adjustment: Approximately 1 km/h*1 or 1.6 km/h*2 each time the lever is pressed.
Major adjustment: The set speed continuously increases or decreases until you release the lever.

*1: When the set speed is displayed in "km/h"
*2: When the set speed is displayed in "MPH"

Canceling and resuming constant speed control

  1. Pull the lever toward you to cancel constant speed control.

    The set speed is also canceled when you depress the brake pedal or the clutch pedal (manual transmission only).

  2. Push the lever up to resume constant speed control.

    However, the set speed can be resumed when the vehicle is traveling above approximately 40 km/h.

    Toyota CH-R. Utilisation des systèmes d'aide à la conduite

■ Operating conditions for cruise control

Vehicles with Multidrive

  • The shift lever is in D.
  • The vehicle is traveling at more than approximately 40 km/h.

Vehicles with a manual transmission

The vehicle is traveling at more than approximately 40 km/h.

■ Acceleration after setting the vehicle speed

  • The vehicle can be accelerated normally by depressing the accelerator pedal. After acceleration, the set speed is restored.
  • Without canceling cruise control, you can increase the set speed by accelerating the vehicle to the desired speed, then pushing the lever down to set the new speed.

■ Automatic deactivation of cruise control

Cruise control is automatically canceled in the following situations.

  • The actual vehicle speed is more than approximately 16 km/h below the set speed.

    At this point, the set speed is no longer stored.

  • The actual vehicle speed is below approximately 40 km/h.
  • The VSC system is operating.
  • The TRC system has been operating for some time.
  • When you turn off the VSC system or TRC system by pressing the VSC OFF switch.
  • The speed limiter is active. (on equipped models)

■ If the message "Check cruise control system. Visit your dealer." is shown on the multi-information display Press the "ON-OFF" button once to turn the system off, then press it again to turn it back on.

If the speed cannot be set, or if cruise control cancels immediately after being turned on, the cruise control system may be malfunctioning. Have the vehicle inspected by a Toyota dealer, a Toyota-authorized repairer, or any reliable repairer.

WARNING

■ To prevent accidental operation of cruise control Turn cruise control off with the "ON-OFF" button when you are not using it.

■ Situations in which cruise control should not be used Do not use cruise control in the following situations.

You may lose control of the vehicle and cause an accident, resulting in serious injury or death.

  • In heavy traffic
  • On roads with very tight bends
  • On winding roads
  • On slippery roads (for example wet, icy or snow-covered roads)
  • On steep downhill grades
    The vehicle may exceed the set speed on steep downhill grades.
  • When your vehicle is towing a caravan or trailer, or during emergency towing