Audi 80 Quiz
Transmission and Driveline

Inspection of Drive Shaft Boots

In this manual: Transmission and Driveline
Technical Description — 39Engines — 41Exhaust System — 13Cooling System — 28Fuel tank and fuel pump — 12Air Filter and Intake Ducts — 13Mono-Motronic Injection System — 18Digifant Injection System — 19KE-III-Jetronic Injection System — 35MPI and MPFI Injection Systems — 32Clutch — 11Transmission and Driveline — 21Suspension and Steering — 33Brake System — 41Anti-lock brake system — 8Wheels and Tires — 13Body Electrical System — 35Ignition System — 24Lighting — 14Signaling Devices — 7Instruments and Auxiliary Equipment — 54Heating and Ventilation — 7Body Components — 18Troubleshooting — 6Specifications — 13
~1min read

The drive shaft joints are protected from moisture and dirt by rubber boots (gaiters). Therefore, regularly check these boots for cracks.


PROCEDURE

Raise the vehicle and secure it, depending on which drive wheel is being serviced.

Slowly rotate the corresponding shaft and inspect the boot for cracks or holes. Traces of grease may also indicate a leak.

Are the clamps tight?
Replace damaged boots as soon as possible, otherwise water entering the joints will destroy them, and joint replacement is quite expensive!

Test yourself

A quick Audi 80 quiz: every answer comes with an explanation and a link to the manual page.