Kia Cadenza VG Owner's Manual Quiz
Engine Control System/Fuel System

Fuel Tank Pressure Sensor (FTPS) Repair Procedures

In this manual: Engine Control System/Fuel System
General Information — 15Engine Mechanical System — 95Engine Electrical System — 54Emission Control System — 24Engine Control System/Fuel System — 115Automatic Transmission — 91Drive Shaft and Axle — 13Suspension System — 35Steering — 19Restraints — 46Brake System — 43Body (Interior and Exterior) — 51Body Electrical System — 245Heating, Ventilation, and Air Conditioning — 56
7steps
~42min
2/5difficulty
Done 0 of 7

Inspection

  1. Connect the GDS to the Data Link Connector (DLC).
  2. Measure the output voltage of the FTPS.

    Specification: Refer to "Specifications"

Removal

  1. Turn the ignition switch OFF and disconnect the negative (-) battery cable.
  2. Remove the luggage compartment floor covering.
  3. Remove the service cover (A).
  4. Disconnect the fuel tank pressure sensor connector.
  5. Remove the fuel tank pressure sensor (A) by releasing the hooks in the vertical direction.

Installation
  • Install the component with the specified torque.
  • Note that internal damage may occur if the component is dropped. If the component has been dropped, inspect it before installation.
  • Insert the sensor into the mounting hole, being careful not to damage it during installation.
  1. Install in the reverse order of removal.

Test yourself

A quick Kia Cadenza VG Owner's Manual quiz: every answer comes with an explanation and a link to the manual page.