Kia Cadenza VG Owner's Manual Quiz
Engine Control System/Fuel System

Manifold Absolute Pressure (MAP) Sensor Repair Procedures

In this manual: Engine Control System/Fuel System
General Information — 15Engine Mechanical System — 95Engine Electrical System — 54Emission Control System — 24Engine Control System/Fuel System — 115Automatic Transmission — 91Drive Shaft and Axle — 13Suspension System — 35Steering — 19Restraints — 46Brake System — 43Body (Interior and Exterior) — 51Body Electrical System — 245Heating, Ventilation, and Air Conditioning — 56
5steps
~30min
2/5difficulty
0102030405011.89N·mlb·ft
Tightening torque found on this page
Done 0 of 5

Inspection

  1. Connect the GDS to the Data Link Connector (DLC).
  2. Measure the MAP sensor output voltage at idle and with the ignition ON.
    Condition Output voltage (V)
    IGNITION ON Approx. 4.44 V
    Idle Approx. 0.75 V

Removal

  1. Turn the ignition switch OFF and disconnect the negative (-) battery cable.
  2. Disconnect the MAP sensor connector (A).
  3. Remove the mounting bolt (B) and pull the sensor straight up from the surge tank.

Installation
  • Install the component with the specified torque.
  • Note that internal damage may occur if the component is dropped. If the component has been dropped, inspect it before installation.
  • Insert the sensor into the mounting hole, being careful not to damage it during installation.
  1. To install, reverse the removal procedure. Manifold Absolute Pressure Sensor Mounting Bolt: 9.8 ~ 11.8 N·m

Test yourself

A quick Kia Cadenza VG Owner's Manual quiz: every answer comes with an explanation and a link to the manual page.