Canister Close Valve (CCV) Repair Procedures

Inspection

1. 1
   Turn the ignition off.
2. 2
   Disconnect the CCV connector.
3. 3
   Measure the resistance between terminals 1 and 2 of the CCV.
4. 4
   Make sure the resistance is within specification.

   Specification: Refer to "Specifications"

5. 5
   Disconnect the vapor hose connected to the canister from the CCV.
6. 6
   Connect a vacuum pump to the nipple.
7. 7
   Ground the CCV control line and apply battery voltage to the CCV power line.
8. 8
   Create a vacuum and check valve operation.

   Specifications: Vacuum must be maintained.

Removal

1. 1
   Turn the ignition switch OFF and disconnect the negative (-) battery cable.
2. 2
   Raise the vehicle.
3. 3
   Disconnect the canister close valve connector (A).
4. 4
   Disconnect the vent hose (B) from the fuel tank air filter and the canister close valve.
5. 5
   Remove the fuel tank air filter assembly by removing the bolts (C).

   

6. 6
   Release the lever (A), then separate the canister close valve (B) from the fuel tank air filter (C) by turning it in the direction of the arrow in the illustration.

   

   

Installation

• Install the component with the specified torque.
• Note that internal damage may occur if the component is dropped. In this case, inspect it before use.

1. Install in the reverse order of removal.