Kia Cadenza VG Owner's Manual Quiz
Engine Control System/Fuel System

CVVT Oil Temperature Sensor (OTS) Repair Procedures

In this manual: Engine Control System/Fuel System
General Information — 15Engine Mechanical System — 95Engine Electrical System — 54Emission Control System — 24Engine Control System/Fuel System — 115Automatic Transmission — 91Drive Shaft and Axle — 13Suspension System — 35Steering — 19Restraints — 46Brake System — 43Body (Interior and Exterior) — 51Body Electrical System — 245Heating, Ventilation, and Air Conditioning — 56
8steps
~48min
2/5difficulty
02040608010041.130N·mlb·ft
Tightening torque found on this page
Done 0 of 8

Inspection

  1. Turn the ignition off.
  2. Disconnect the OTS connector.
  3. Remove the OTS. (Refer to "Removal")
  4. After immersing the sensor thermistor in engine coolant, measure the resistance between terminals 1 and 2 of the OTS.
  5. Make sure the resistance is within specification.

    Specification: Refer to "Specifications"

Removal

  1. Turn the ignition switch OFF and disconnect the negative (-) battery cable.
  2. Remove the air cleaner assembly. (Refer to Engine Mechanical System - "Air Cleaner")
  3. Disconnect the connector (A) and remove the CVVT oil temperature sensor (B).

Installation
  • Install the component with the specified torque.
  • Be aware that internal damage may occur if the component is dropped. If the component has been dropped, inspect it before installation.
  • Apply sealant (LOCTITE FED546 or equivalent) to the sensor.
  • Insert the sensor into the mounting hole, being careful not to damage it during installation.
  1. To install, reverse the removal procedure. CVVT oil temperature sensor: 34.3 ~ 41 N·m

Test yourself

A quick Kia Cadenza VG Owner's Manual quiz: every answer comes with an explanation and a link to the manual page.