Kia Cadenza VG Owner's Manual Quiz
Engine Control System/Fuel System

Crankshaft Position Sensor (CKPS) Repair Procedures

In this manual: Engine Control System/Fuel System
General Information — 15Engine Mechanical System — 95Engine Electrical System — 54Emission Control System — 24Engine Control System/Fuel System — 115Automatic Transmission — 91Drive Shaft and Axle — 13Suspension System — 35Steering — 19Restraints — 46Brake System — 43Body (Interior and Exterior) — 51Body Electrical System — 245Heating, Ventilation, and Air Conditioning — 56
4steps
~24min
2/5difficulty
010203040509.87N·mlb·ft
Tightening torque found on this page
Done 0 of 4

Inspection

  1. Check the CMPS and CKPS signal waveforms using the GDS.

    Specification: Refer to Waveform.

Removal

  1. Turn the ignition switch OFF and disconnect the negative (-) battery cable.
  2. Remove the air cleaner assembly. (Refer to Engine Mechanical System - "Air Cleaner")
  3. Disconnect the crankshaft position sensor connector (A).
  4. Remove the mounting bolt (B) and pull the sensor straight out of the transaxle housing.

Installation
  • Install the component with the specified torque.
  • Note that internal damage may occur if the component is dropped. If the component has been dropped, inspect it before installation.
  • Apply engine oil to the O-ring.
  • Insert the sensor into the mounting hole, being careful not to damage it during installation.
  1. To install, reverse the removal procedure. Crankshaft Position Sensor Mounting Bolt: 6.9 ~ 9.8 N·m

Test yourself

A quick Kia Cadenza VG Owner's Manual quiz: every answer comes with an explanation and a link to the manual page.