Kia Forte BD Quiz
DCT (Dual Clutch Transmission) System

Input Speed Sensor 2

In this manual: DCT (Dual Clutch Transmission) System
General Information — 8Maintenance — 32Engine Mechanical System — 47Engine Electrical System — 17Emission Control System — 10Engine Control System/Fuel System — 32Clutch System — 11Manual Transmission — 11DCT (Dual Clutch Transmission) System — 16Drive Shaft and Axle — 8Suspension System — 26Steering — 9Restraints — 11Brake System — 27Body (Interior and Exterior) — 119Body Electrical System — 98Heating, Ventilation, and Air Conditioning — 27
2steps
~12min
1/5difficulty
0102030405011.89N·mlb·ft
Tightening torque found on this page
Done 0 of 2

Components and Component Location

Component Location

1. Input Shaft Speed Sensor 1 (Odd) 2. Input Shaft Speed Sensor 2 (Even)

Specifications

Specification

Item Specification
Type Hall Effect Sensor
Operating Condition -40 to 302 °F (-40 to 150 °C)
Output Signal High: 11.8–16.8 mA
Low: 5.9–8.4 mA

Description and Operation

Description

  • The input shaft speed sensor is important because it detects the input shaft speed and sends this information to the Transmission Control Module (TCM).

  • This data is required for all operations, including feedback control, shift control, and detection of failure of other sensors.

Circuit Diagrams

Wiring Diagram

Repair Procedures

Removal

  1. Remove the clutch actuator.

    (Refer to Dual Clutch Transmission Control System - "Clutch Actuator Assembly")

  2. Remove the input speed sensor (A) by loosening the bolts after disconnecting the connector (B).

    Tightening Torque: 9.8–11.8 N·m

Installation

  1. Install in the reverse order of removal.

Test yourself

A quick Kia Forte BD quiz: every answer comes with an explanation and a link to the manual page.