Engine Starting System

Ignition Coil

~1min read

GENERAL INFORMATION

For carburetor engines without catalytic converter only. Removal

PROCEDURE

1. Disconnect the battery ground cable.

2. Отверните от катушки (находится слева на головке цилиндров) высоковольтный

2. Disconnect the high-voltage wire from the coil (located on the left side of the cylinder head).

3. Отсоедините разъем.

3. Disconnect the connector.

4. Отверните гайки и болты и снимите катушку (указаны стрелками).

4. Remove the nuts and bolts and remove the coil (indicated by arrows).

Inspection

PROCEDURE

1. Check the resistance between terminals + and -, and between terminal + and the high-voltage wire, and compare with specifications (resistance values are given for 20 °C).

2. Check the circuit between the high-voltage wire and the body.

3. If any faults are found, replace the coil.

Installation: Installation is performed in the reverse order.

Test yourself

A quick Nissan Sunny quiz: every answer comes with an explanation and a link to the manual page.