Parking Assist / Monitor System

Steering angle sensor (C1A47)

~2min read

DESCRIPTION

The blind spot monitor sensor receives steering angle signals from the steering angle sensor via CAN communication.

DTC No.

Detection Item

DTC Detection Condition

Suspected Area

C1A47

Steering angle sensor

A malfunction signal is output by the steering angle sensor

  • Steering angle sensor
  • Left Blind Spot Sensor (Master)
  • Right Blind Spot Sensor (Slave)

PRECAUTION / NOTICE / HINT

NOTICE:

When checking DTCs, make sure the blind spot monitor system is ON.

PROCEDURE

  1. CHECK DTCs

(a) Turn the ignition switch OFF.

(b) Turn the ignition switch to ON.

(c) Check whether other DTCs are output and check whether the same DTC is output again.

Body Electrical > Blind Spot Monitor Master > Trouble Codes Body Electrical > Blind Spot Monitor Slave > Trouble Codes

OK:

No DTC is output.

OK

USE SIMULATION METHOD TO CHECK

NG
  1. REPLACE STEERING ANGLE SENSOR

(a) Replace the steering angle sensor.

Click here

NEXT
  1. CHECK DTCS AGAIN

(a) Turn the ignition switch OFF.

(b) Turn the ignition switch to ON.

(c) Check whether other DTCs are output and check whether the same DTC is output again.

Body Electrical > Blind Spot Monitor Master > Trouble Codes Body Electrical > Blind Spot Monitor Slave > Trouble Codes

Result:

Result

Proceed to

No DTC is output.

A

DTC C1A47 is output ("Blind Spot Monitor Master").

B

DTC C1A47 is output ("Blind Spot Monitor Slave").

C

A

END

B

REPLACE LEFT (MAIN) BLIND SPOT MONITOR SENSOR

C

REPLACE RIGHT (SUB) BLIND SPOT MONITOR SENSOR