Parking Assist / Monitor System

Destination information not set (C1AB8)

~2min read

DESCRIPTION

This DTC is stored when the correct destination information is not sent from the main body ECU (multiplex network body ECU) and the destination information cannot be confirmed after a blind spot monitor sensor has been replaced.

DTC No.

Detection Item

DTC Detection Condition

Suspected Area

C1AB8

Destination information undefined

The blind spot monitor sensor cannot communicate with the main body ECU

  • CAN communication system
  • Main body ECU (multiplex network body ECU)
  • Left Blind Spot Sensor (Master)
  • Right Blind Spot Sensor (Slave)

PRECAUTION / NOTICE / HINT

NOTICE:

  • When checking DTCs, make sure the blind spot monitor system is ON.
  • Before replacing the main body ECU (multiplex network body ECU), refer to the registration section*1.

    Click here

    *1: with Smart Key System

PROCEDURE

  1. CHECK DTCs

(a) Check whether CAN communication system DTCs are output.

Click here

OK:

No CAN communication system DTCs are output.

NG

GO TO CAN COMMUNICATION SYSTEM

OK
  1. REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)

(a) Replace the main body ECU (multiplex network body ECU).

Click here

NEXT
  1. CHECK DTCS AGAIN

(a) Check whether other DTCs are output and check whether the same DTC is output again.

Click here

Body Electrical > Blind Spot Monitor Master > Trouble Codes Body Electrical > Blind Spot Monitor Slave > Trouble Codes

Result:

Result

Proceed to

No DTC is output.

A

DTC C1AB8 is output ("Blind Spot Monitor Master").

B

DTC C1AB8 is output ("Blind Spot Monitor Slave").

C

A

END

B

REPLACE LEFT (MAIN) BLIND SPOT MONITOR SENSOR

C

REPLACE RIGHT (SUB) BLIND SPOT MONITOR SENSOR