Parking Assist / Monitor System

How to Use Troubleshooting

~3min read

PRECAUTION / NOTICE / HINT

HINT:

  • Use the following procedure to troubleshoot the Blind Spot Monitor system.
  • *: Use the Techstream.

PROCEDURE

  1. VEHICLE BROUGHT TO WORKSHOP

NEXT
  1. CUSTOMER PROBLEM ANALYSIS

HINT:

If there are scratches or impact marks on the rear bumper, check the aiming of the blind spot monitor sensor. If any abnormalities are found, check the installation condition of the blind spot monitor sensor.

NEXT
  1. CHECK BATTERY VOLTAGE

(a) Measure the battery voltage.

Standard voltage:

11 à 14 V

If the voltage is below 11 V, charge or replace the battery before proceeding to the next step.

NEXT
  1. CHECK CAN COMMUNICATION SYSTEM*

(a) Use the Techstream to check whether the CAN communication system is operating normally.

Click here

Result:

Result

Proceed to

No CAN communication system DTCs are output.

A

CAN communication system DTCs are output.

B

B

GO TO CAN COMMUNICATION SYSTEM

A
  1. CHECK DTCs AND FREEZE FRAME DATA*

(a) Refer to the Blind Spot Monitor system DTC check/clear procedure.

Click here

Body Electrical > Blind Spot Monitor Master > Trouble Codes Body Electrical > Blind Spot Monitor Slave > Trouble Codes

(b) Record or print the DTCs and freeze frame data, if necessary.

Click here

Result:

Result

Proceed to

No DTCs are output.

A

DTCs are output.

B

B

GO TO DIAGNOSTIC TROUBLE CODE CHART

A
  1. SYMPTOM TROUBLESHOOTING TABLE

(a) Refer to the Symptom Troubleshooting Table.

Click here

Result:

Result

Proceed to

The malfunction is not listed in the Symptom Troubleshooting Table.

A

The malfunction is listed in the Symptom Troubleshooting Table.

B

HINT:

If the symptom does not recur and no DTCs are output, try to reproduce the symptoms.

Click here

B

REFER TO SYMPTOM TROUBLESHOOTING TABLE

A
  1. PERFORM CIRCUIT INSPECTION BASED ON MALFUNCTION SYMPTOM*

(a) Refer to the ECU terminals.

Click here

(b) Refer to the "Diagnostic System" section.

Click here

(c) Refer to the Data List / Active Test.

Click here

NEXT
  1. ADJUST, REPAIR OR REPLACE

Result:

Result

Proceed to

When adjusting or repairing

A

When replacing

B

B

GO TO STEP 10

A
  1. CLEAR DTCs

(a) Clear the DTCs.

Click here

Body Electrical > Blind Spot Monitor Master > Clear DTCs Body Electrical > Blind Spot Monitor Slave > Clear DTCs
NEXT

GO TO STEP 10

  1. PERFORM AIMING CONFIRMATION

(a) Check the blind spot monitor aiming display and adjust the blind spot monitor aiming.

Click here

NEXT
  1. PERFORM OPERATION CONFIRMATION TEST*

NEXT

END