Power supply circuit
DESCRIPTION
This circuit supplies the power necessary for the blind spot monitor sensor to operate.
WIRING DIAGRAM
PRECAUTION / NOTICE / HINT
NOTICE:
Check the fuses for the circuits related to this system before performing the following procedure.
PROCEDURE
CHECK HARNESS AND CONNECTOR (POWER SOURCE FOR LEFT BLIND SPOT MONITOR SENSOR (MASTER))
*a |
Front view of wire harness side connector (to Left Blind Spot Monitor Sensor (Main)) |
(a) Disconnect the connector from the left blind spot monitor sensor (master).
(b) Measure the voltage according to the value(s) in the table below.
Standard voltage:
Tester Connection | Ignition switch position | Specified Condition |
|---|---|---|
M62-5 (BLB) - Body ground |
Ignition Switch in ON position |
11 à 14 V |
M62-5 (BLB) - Body ground |
Ignition Switch in OFF position |
Below 1 V |
| NG | REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
CHECK HARNESS AND CONNECTOR (LEFT BLIND SPOT MONITOR SENSOR (MASTER) - BODY GROUND)
(a) Measure the resistance according to the value(s) in the table below.
Standard resistance:
Tester Connection | Condition | Specified Condition |
|---|---|---|
M62-10 (BLGD) - Body ground |
Always |
Below 1 Ω |
| NG | REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
CHECK HARNESS AND CONNECTOR (POWER SOURCE TO RIGHT BLIND SPOT MONITOR SENSOR (AUXILIARY))
*a |
Front view of wire harness side connector (to Right Blind Spot Monitor Sensor (Auxiliary)) |
(a) Disconnect the Right Blind Spot Monitor Sensor (Auxiliary) connector.
(b) Measure the voltage according to the value(s) in the table below.
Standard voltage:
Tester Connection | Ignition switch position | Specified Condition |
|---|---|---|
M63-5 (BRB) - Body ground |
Ignition Switch in ON position |
11 à 14 V |
M63-5 (BRB) - Body ground |
Ignition Switch in OFF position |
Below 1 V |
| NG | REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
CHECK HARNESS AND CONNECTOR (RIGHT BLIND SPOT MONITOR SENSOR (AUXILIARY) - BODY GROUND)
(a) Measure the resistance according to the value(s) in the table below.
Standard resistance:
Tester Connection | Condition | Specified Condition |
|---|---|---|
M63-10 (BRGD) - Body ground |
Always |
Below 1 Ω |
| OK | GO TO APPLICABLE SYSTEM AS INDICATED IN THE PROBLEM SYMPTOMS TABLE |
| NG | REPAIR OR REPLACE HARNESS OR CONNECTOR |