Parking Assist / Monitor System

Diagnostic System

~3min read

DIAGNOSTIC SYSTEM

DESCRIPTION

(a) Blind spot monitor data and diagnostic trouble codes (DTCs) can be read from the vehicle's Data Link Connector 3 (DLC3). If the system does not appear to operate correctly, use the Techstream to find possible malfunctions and carry out repairs.

CHECK DLC3

(a) Check DLC3.

Click here

DIAGNOSTIC FUNCTION

(a) The blind spot monitor system displays an error message on the multi-information display to inform the driver that the system is temporarily unavailable due to a malfunction.

  • When the system is temporarily unavailable:

    The multi-information display shows "Blind Spot Monitor Unavailable".

  • When the system is unavailable due to a malfunction:

    The multi-information display shows "Blind Spot Monitor System Malfunction. Visit Your Dealer".

DTC HISTORY

HINT:

The DTC history for a blind spot monitor sensor can be displayed or cleared.

(a) Check DTC history

(1) Connect the Techstream to the DLC3.

(2) Turn the ignition switch ON.

(3) Turn on the Techstream.

(4) Set the blind spot monitor system to ON.

(5) Select the following menus: Body Electrical / Blind Spot Monitor Master or Blind Spot Monitor Slave / Utility / BSM Master Abnormal History or BSM Slave Abnormal History.

Body Electrical > Blind Spot Monitor Master > Utility

BSM Master Abnormal History

Body Electrical > Blind Spot Monitor Slave > Utility

BSM Slave Abnormal History

(6) Check the results displayed for the abnormal history check.

HINT:

  • If "Yes" is displayed, check the affected area column for each item.
  • Abnormal history is recorded only for the blind spot monitor sensor where a malfunction was detected.
  • If "No" is displayed, refer to the trouble symptoms table.

    Click here

DTC History Table

Tester display

Item Description

Suspected Area

History of Module Blockage

History of blind spot sensor detection malfunctions caused by snow, rain, etc. on the bumper

  • Check whether a bumper that is not compatible with the blind spot monitor sensors (such as a non-genuine part) is installed
  • Check whether foreign matter is adhered to the bumper
  • Check whether foreign matter is present between the sensors and the bumper assembly

History of Low Voltage

History of low battery supply voltage to the blind spot monitor sensor

Power supply circuit

Click here

History of High Voltage

History of high battery supply voltage to the blind spot monitor sensor

History of Low Temperature

History of low temperature of the blind spot monitor sensor

  • Check the outside temperature
  • Check whether foreign matter is adhered to the blind spot sensors and their surrounding areas

History of High Temperature

History of high temperature of the blind spot monitor sensor

(b) Clearing the Abnormal History

(1) Connect the Techstream to the DLC3.

(2) Turn the ignition switch ON.

(3) Turn on the Techstream.

(4) Set the blind spot monitor system to ON.

(5) Select the following menus: Body Electrical / Blind Spot Monitor Master or Blind Spot Monitor Slave / Utility / BSM Master Abnormal History or BSM Slave Abnormal History.

Body Electrical > Blind Spot Monitor Master > Utility

BSM Master Abnormal History

Body Electrical > Blind Spot Monitor Slave > Utility

BSM Slave Abnormal History

(6) Clear the abnormal history.