Parking Assist / Monitor System

Yaw rate sensor (C1A46)

~2min read

DESCRIPTION

The blind spot monitor sensor receives yaw rate sensor signals from the airbag sensor assembly via CAN communication.

DTC No.

Detection Item

DTC Detection Condition

Suspected Area

C1A46

Yaw rate sensor

A malfunction signal is output from the yaw rate and acceleration sensor.

  • Vehicle Stability Control System
  • Left Blind Spot Sensor (Master)
  • Right Blind Spot Sensor (Slave)

PRECAUTION / NOTICE / HINT

NOTICE:

When checking DTCs, make sure the blind spot monitor system is ON.

PROCEDURE

  1. CHECK FOR OTHER DTCS OUTPUT (VEHICLE STABILITY CONTROL SYSTEM)

(a) Check for DTCs related to the vehicle stability control system.

Click here

OK:

DTCs related to the vehicle stability control system are not output.

NG

GO TO VEHICLE STABILITY CONTROL SYSTEM

OK
  1. CHECK DTCS AGAIN

(a) Turn the ignition switch OFF.

(b) Turn the ignition switch to ON.

(c) Check whether other DTCs are output and check whether the same DTC is output again.

Body Electrical > Blind Spot Monitor Master > Trouble Codes Body Electrical > Blind Spot Monitor Slave > Trouble Codes

Result:

Result

Proceed to

No DTC is output.

A

DTC C1A46 is output ("Blind Spot Monitor Master").

B

DTC C1A46 is output ("Blind Spot Monitor Slave").

C

A

USE SIMULATION METHOD TO CHECK

B

REPLACE LEFT (MAIN) BLIND SPOT MONITOR SENSOR

C

REPLACE RIGHT (SUB) BLIND SPOT MONITOR SENSOR