Toyota Corolla Quiz
Emission Control System

Crankshaft Position Sensor

In this manual: Emission Control System
Owner's Manual — 7Controls and Instruments — 49Engine Starting and Vehicle Operation — 5Actions if the Engine Does Not Start — 18Maintenance — 30Gasoline Engines - Repair Procedures Without Engine Removal from Vehicle — 17Gasoline Engines - Removal and Overhaul — 21Diesel Engine — 26Engine Electrical Equipment — 13Cooling and Heating Systems — 17Fuel and Exhaust Systems — 14Emission Control System — 19Manual transmission — 6Automatic transmission — 9Clutch and Axle Shafts — 11Brake System — 20Suspension and Steering — 24Body — 29Electrical System — 24Wiring Diagrams — 24
~1min read

Место установки датчика угла поворота коленвала
Crankshaft Position Sensor Location

On some recent-model vehicles, the crankshaft position sensor (indicated by the arrow) is located near the timing belt cover, next to the pulley. The sensor sends a signal to the control module, which uses it to accurately determine the crankshaft angle.

Inspection

PROCEDURE
1. Measure the crankshaft sensor resistance. It must be within 1.630–3.225 ohms depending on temperature: resistance increases as temperature rises. If the measured values are not within this range, replace the sensor.
2. To replace the sensor, remove the pulley (refer to subsection 3.1.1.6), disconnect the connector and remove the sensor mounting bolts.
3. Install the sensor in the reverse order of removal.

Test yourself

A quick Toyota Corolla quiz: every answer comes with an explanation and a link to the manual page.