Toyota RAV4 Quiz
Brake control

Brake warning light does not come on

In this manual: Brake control
Introduction — 37Interior — 12Exterior — 432Az-fe engine mechanical — 1552Az-fe ignition — 182Az-fe charging — 232Az-fe emission control — 82az-fe exhaust — 32Az-fe fuel — 72Az-fe lubrication — 4Brake — 17Brake control — 63U140f automatic transaxle — 59Instrument panel — 8Suspension — 18Drive shaft — 23Axle — 6Tire and wheel — 30Air conditioning — 93Lighting — 45Cruise control — 21Differential — 12Door lock — 31Engine immobiliser — 21Horn — 5Can communication — 27Mirror — 5Parking brake — 5Power steering — 27Propeller shaft — 3Seat — 29Seat belt — 27Sliding roof — 25Steering column — 6Wiper and washer — 11Supplemental restraint system — 95Other system — 5Maintenance — 14
6steps
~36min
2/5difficulty
Done 0 of 6
Wiring diagram

Refer to the brake warning light circuit (see page bc-145).

Inspection procedure
  1. Check can communication system
  2. Check if the can communication system dtc is output (see page ca-34).
Result


  1. Perform active test by intelligent tester (brake warning light)
  2. Select the active test, generate a control command, and then check that brake warning light operates.
    Toyota RAV4. Perform active test by intelligent tester (brake warning light)

Ok: the brake warning light turns on or off.


  1. Inspect combination meter
  2. Inspect the combination meter (see page me-15).

Replace abs and traction actuator assembly

Test yourself

A quick Toyota RAV4 quiz: every answer comes with an explanation and a link to the manual page.