Toyota RAV4 Quiz
Brake control

Slip indicator light does not come on

In this manual: Brake control
Introduction — 37Interior — 12Exterior — 432Az-fe engine mechanical — 1552Az-fe ignition — 182Az-fe charging — 232Az-fe emission control — 82az-fe exhaust — 32Az-fe fuel — 72Az-fe lubrication — 4Brake — 17Brake control — 63U140f automatic transaxle — 59Instrument panel — 8Suspension — 18Drive shaft — 23Axle — 6Tire and wheel — 30Air conditioning — 93Lighting — 45Cruise control — 21Differential — 12Door lock — 31Engine immobiliser — 21Horn — 5Can communication — 27Mirror — 5Parking brake — 5Power steering — 27Propeller shaft — 3Seat — 29Seat belt — 27Sliding roof — 25Steering column — 6Wiper and washer — 11Supplemental restraint system — 95Other system — 5Maintenance — 14
6steps
~36min
2/5difficulty
Done 0 of 6
Description

Refer to the description of "slip indicator light remains on" (see page bc-152).

Wiring diagram

Refer to the slip indicator light circuit (see page bc-152).

Inspection procedure Notice:

When replacing the abs and traction actuator, perform the zero point calibration (see page bc- 24).

  1. Check can communication system
  2. Check if the can communication system dtc is output (see page ca-34).
Result


  1. Perform active test by intelligent tester (slip indicator light)
  2. Using the intelligent tester's active test, generate a control command, and then check that the slip indicator light operates.
    Toyota RAV4. Perform active test by intelligent tester (slip indicator light)

Ok: the slip indicator light turns on and off.


Replace abs and traction actuator assembly
  1. Check combination meter
  2. Inspect the combination meter (see page me-15).

Replace abs and traction actuator assembly

Test yourself

A quick Toyota RAV4 quiz: every answer comes with an explanation and a link to the manual page.