Freeze frame data

1. Freeze frame data

Hint:

• Whenever a dtc is detected or the abs operates, the skid control ecu stores the current vehicle (sensor) state as freeze frame data.
• The skid control ecu stores the number of times (maximum: 31) the ignition switch has been turned from off to on since the last time the abs was activated. However, if the vehicle was stationary or running at a low speed (7 km/h [4,3 mph] or less), or if a dtc is detected, the skid control ecu stops counting.
• Freeze frame data at the time the abs operates: the skid control ecu stores and updates the data whenever the abs system operates.

When the ecu stores data at the time a dtc is detected, the data stored when the abs operated is erased.

Freeze frame data at the time a dtc is detected: when the skid control ecu stores data at the time a dtc is detected, no updates will be performed until the data is cleared.

1. 1
   Connect the intelligent tester (with can vim) to the dlc3.
2. 2
   Turn the ignition switch on.
3. 3
   Turn the tester on.
4. 4
   From the display on the tester, select "freeze frame data".