Auto lsd indicator light remains on

This is the auto lsd switch for 2wd. When the auto lsd switch is pushed on, the auto lsd function is available and the auto lsd indicator light illuminates.

The auto lsd does not operate even if the auto lsd switch is pressed under the following conditions:

• The trc or vsc system is faulty.
• The temperature inside the hydraulic brake booster increases and the auto lsd operation is suspended.

1. 1
   Check can communication system
2. 2
   Check if the can communication system dtc is output (see page ca-34).

Result

1. 1
   Check skid control ecu connector
2. 2
   Check if the skid control ecu connector is securely connected.

1. 1
   Check wire harness (skid control ecu - body ground)
2. 2
   Disconnect the a19 ecu connector.
3. 3
   Measure the resistance of the wire harness side connector.

Standard resistance

1. 1
   Inspect auto lsd switch
2. 2
   Remove the auto lsd switch.
3. 3
   Measure the resistance of the switch.

Standard resistance

5. Check wire harness (skid control ecu - traction control switch)

1. 1
   Disconnect the a19 ecu connector.
2. 2
   Disconnect the e51 switch connector.
3. 3
   Measure the resistance of the wire harness side connectors.

Standard resistance

1. 1
   Check combination meter
2. 2
   Check the combination meter (see page me-15).