Engine, Hybrid System
Automatic Disconnecting Differential Motor Control Circuit High (P17A2)
Done 0 of 8
DESCRIPTION
This DTC is detected when a short to B+ is detected in the A.D.D. shift motor drive circuit.
WIRING DIAGRAM
Refer to DTCs P17A0 and P17A1 (See page ).
PROCEDURE
CHECK DIFFERENTIAL VACUUM ACTUATOR ASSEMBLY (A.D.D. SHIFT MOTOR)
(a) Disconnect the 4 wheel drive control ECU connector.
(b) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
Tester Connection | Switch Condition | Specified Condition |
A25-1 (DM1) or A25-2 (DM2) - Body ground |
Ignition switch ON |
Below 1 V |
Text in Illustration
*a |
Front view of wire harness connector
(to 4 Wheel Drive Control ECU) |
| OK |
 |
REPLACE 4 WHEEL DRIVE CONTROL ECU |
| NG |
 |
|
CHECK HARNESS AND CONNECTOR (4 WHEEL DRIVE CONTROL ECU AND DIFFERENTIAL VACUUM ACTUATOR ASSEMBLY - BODY GROUND)
(a) Disconnect the A25 4 wheel drive control ECU connector.
(b) Disconnect the G1 A.D.D. actuator (differential vacuum actuator assembly) connector.
(c) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
Tester Connection | Switch Condition | Specified Condition |
A25-1 (DM1) or G1-1 (DM1) - Body ground |
Ignition switch ON |
Below 1 V |
A25-2 (DM2) or G1-2 (DM2) - Body ground |
Ignition switch ON |
Below 1 V |
| OK |
 |
REPLACE DIFFERENTIAL VACUUM ACTUATOR ASSEMBLY |
| NG |
 |
REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
Was this page helpful?