Engine, Hybrid System
Automatic Disconnecting Differential Motor Control Circuit Open (P17A0,P17A1)
Done 0 of 12
DESCRIPTION
This DTC is detected when an open circuit or short to ground in the A.D.D. shift motor drive circuit is detected.
WIRING DIAGRAM
PROCEDURE
CHECK DIFFERENTIAL VACUUM ACTUATOR ASSEMBLY (A.D.D. SHIFT MOTOR)
(a) Disconnect the 4 wheel drive control ECU connector.
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection | Condition | Specified Condition |
A25-1 (DM1) - A25-2 (DM2) |
Always |
2 Ω or less |
A25-1 (DM1) or A25-2 (DM2) - Body ground |
Always |
10 kΩ or higher |
Text in Illustration
*a |
Front view of wire harness connector
(to 4 Wheel Drive Control ECU) |
| OK |
 |
REPLACE 4 WHEEL DRIVE CONTROL ECU |
| NG |
 |
|
CHECK HARNESS AND CONNECTOR (4 WHEEL DRIVE CONTROL ECU - DIFFERENTIAL VACUUM ACTUATOR ASSEMBLY)
(a) Disconnect the A25 4 wheel drive control ECU connector.
(b) Disconnect the G1 A.D.D. actuator (differential vacuum actuator assembly) connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection | Condition | Specified Condition |
A25-1 (DM1) - G1-1 (DM1) |
Always |
Below 1 Ω |
A25-2 (DM2) - G1-2 (DM2) |
Always |
Below 1 Ω |
A25-1 (DM1) or G1-1 (DM1) - Body ground |
Always |
10 kΩ or higher |
A25-2 (DM2) or G1-2 (DM2) - Body ground |
Always |
10 kΩ or higher |
| OK |
 |
REPLACE DIFFERENTIAL VACUUM ACTUATOR ASSEMBLY |
| NG |
 |
REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
Was this page helpful?