Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
Touch select 2-4 and high-low system
Symptom
Suspected Area
See page
When the vehicle is in the 2WD state and the transfer position switch is turned to a position other than 2WD, the 4HI and 4LO indicator lights are not illuminated
CAN communication system
Combination meter assembly
Transfer position switch (open circuit in LO terminal circuit or stuck OFF)
4 wheel drive control ECU
When the vehicle is in the 4H state and the transfer position switch is turned to a position other than 4H, the 4HI indicator light is illuminated and the 4LO indicator light is not illuminated
Transfer position switch (short circuit in 2-4 or LO terminal circuit or stuck ON)
4 wheel drive control ECU
When the vehicle is in the 4L state and the transfer position switch is turned to a position other than 4L, the 4HI indicator light is not illuminated and the 4LO indicator light is illuminated
Transfer position switch (open circuit in 2-4 terminal circuit or stuck OFF)
4 wheel drive control ECU
CAN communication system
The 4HI indicator light is blinking* after operation of the transfer position switch