Engine, Hybrid System
Transfer Shift Motor Control Circuit High (P17AA)
Done 0 of 8
DESCRIPTION
This DTC is detected when a short to B+ is detected in the transfer shift motor drive circuit.
WIRING DIAGRAM
Refer to DTCs P17A8 and P17A9 (See page ).
PROCEDURE
CHECK TRANSFER SHIFT ACTUATOR ASSEMBLY (TRANSFER SHIFT MOTOR)
(a) Disconnect the 4 wheel drive control ECU connector.
(b) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
Tester Connection | Switch Condition | Specified Condition |
A26-1 (TM1) or A26-2 (TM2) - Body ground |
Ignition switch ON |
Below 1 V |
Text in Illustration
*a |
Front view of wire harness connector
(to 4 Wheel Drive Control ECU) |
| OK |
 |
REPLACE 4 WHEEL DRIVE CONTROL ECU |
| NG |
 |
|
CHECK HARNESS AND CONNECTOR (4 WHEEL DRIVE CONTROL ECU AND TRANSFER SHIFT ACTUATOR ASSEMBLY - BODY GROUND)
(a) Disconnect the A26 4 wheel drive control ECU connector.
(b) Disconnect the D67 transfer shift actuator assembly connector.
(c) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
Tester Connection | Switch Condition | Specified Condition |
A26-1 (TM1) or D67-1 (TM1) - Body ground |
Ignition switch ON |
Below 1 V |
A26-2 (TM2) or D67-2 (TM2) - Body ground |
Ignition switch ON |
Below 1 V |
| OK |
 |
REPLACE TRANSFER SHIFT ACTUATOR ASSEMBLY |
| NG |
 |
REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
Was this page helpful?