Engine, Hybrid System
Transfer Shift Motor Position Circuit (P17AB)
Done 0 of 8
DESCRIPTION
This DTC is detected when a short to ground is detected in the limit switch circuit, which detects the position of the transfer shift motor.
WIRING DIAGRAM
PROCEDURE
CHECK HARNESS AND CONNECTOR (4 WHEEL DRIVE CONTROL ECU AND TRANSFER SHIFT ACTUATOR ASSEMBLY - BODY GROUND)
(a) Disconnect the A26 4 wheel drive control ECU connector.
(b) Disconnect the D68 transfer shift actuator assembly connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection | Condition | Specified Condition |
A26-18 (TL1) or D68-1 (TL1) - Body ground |
Always |
10 kΩ or higher |
A26-20 (TL2) or D68-2 (TL2) - Body ground |
Always |
10 kΩ or higher |
A26-26 (TL3) or D68-3 (TL3) - Body ground |
Always |
10 kΩ or higher |
A26-24 (TL4) or D68-4 (TL4) - Body ground |
Always |
10 kΩ or higher |
A26-22 (GTL) or D68-5 (GTL) - Body ground |
Always |
10 kΩ or higher |
| NG |
 |
REPAIR OR REPLACE HARNESS OR CONNECTOR |
| OK |
 |
|
INSPECT TRANSFER SHIFT ACTUATOR ASSEMBLY (LIMIT SWITCH)
(a) Disconnect the D68 transfer shift actuator assembly connector.
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection | Condition | Specified Condition |
1 (TL1) - Body ground |
Always |
10 kΩ or higher |
2 (TL2) - Body ground |
Always |
10 kΩ or higher |
3 (TL3) - Body ground |
Always |
10 kΩ or higher |
4 (TL4) - Body ground |
Always |
10 kΩ or higher |
5 (GTL) - Body ground |
Always |
10 kΩ or higher |
Text in Illustration
*a |
Component without harness connected
(Transfer Shift Actuator Assembly) |
| OK |
 |
REPLACE 4 WHEEL DRIVE CONTROL ECU |
| NG |
 |
REPLACE TRANSFER SHIFT ACTUATOR ASSEMBLY |
|
Was this page helpful?