Engine, Hybrid System
Transfer Shift Motor Control Circuit Circuit Open (P17A8,P17A9)
Done 0 of 12
DESCRIPTION
This DTC is detected when an open circuit or short to ground is detected in the transfer shift motor drive circuit.
WIRING DIAGRAM
PROCEDURE
CHECK TRANSFER SHIFT ACTUATOR ASSEMBLY (TRANSFER SHIFT MOTOR)
(a) Disconnect the 4 wheel drive control ECU connector.
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection | Condition | Specified Condition |
A26-1 (TM1) - A26-2 (TM2) |
Always |
Below 5 Ω |
A26-1 (TM1) or A26-2 (TM2) - Body ground |
Always |
10 kΩ or higher |
Text in Illustration
*a |
Front view of wire harness connector
(to 4 Wheel Drive Control ECU) |
| OK |
 |
REPLACE 4 WHEEL DRIVE CONTROL ECU |
| NG |
 |
|
CHECK HARNESS AND CONNECTOR (4 WHEEL DRIVE CONTROL ECU - TRANSFER SHIFT ACTUATOR ASSEMBLY)
(a) Disconnect the A26 4 wheel drive control ECU connector.
(b) Disconnect the D67 transfer shift actuator assembly connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection | Condition | Specified Condition |
A26-1 (TM1) - D67-1 (TM1) |
Always |
Below 1 Ω |
A26-2 (TM2) - D67-2 (TM2) |
Always |
Below 1 Ω |
A26-1 (TM1) or D67-1 (TM1) - Body ground |
Always |
10 kΩ or higher |
A26-2 (TM2) or D67-2 (TM2) - Body ground |
Always |
10 kΩ or higher |
| OK |
 |
REPLACE TRANSFER SHIFT ACTUATOR ASSEMBLY |
| NG |
 |
REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
Was this page helpful?