Engine, Hybrid System
Transfer Synchronization Actuator Circuit High (P17A7)
Done 0 of 8
DESCRIPTION
This DTC is detected when a short to B+ is detected in the solenoid coil drive circuit.
WIRING DIAGRAM
Refer to DTCs P17A5 and P17A6 (See page ).
PROCEDURE
CHECK SOLENOID COIL SUB-ASSEMBLY
(a) Disconnect the 4 wheel drive control ECU connector.
(b) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
Tester Connection | Switch Condition | Specified Condition |
A26-6 (SCC) - Body ground |
Ignition switch ON |
Below 1 V |
Text in Illustration
*a |
Front view of wire harness connector
(to 4 Wheel Drive Control ECU) |
| OK |
 |
REPLACE 4 WHEEL DRIVE CONTROL ECU |
| NG |
 |
|
CHECK HARNESS AND CONNECTOR (4 WHEEL DRIVE CONTROL ECU AND TRANSFER SHIFT ACTUATOR ASSEMBLY - BODY GROUND)
(a) Disconnect the A26 4 wheel drive control ECU connector.
(b) Disconnect the D67 transfer shift actuator assembly connector.
(c) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
Tester Connection | Switch Condition | Specified Condition |
A26-6 (SCC) or D67-3 (SCC) - Body ground |
Ignition switch ON |
Below 1 V |
| NG |
 |
REPAIR OR REPLACE HARNESS OR CONNECTOR |
| OK |
 |
|
INSPECT SOLENOID COIL SUB-ASSEMBLY
(a) Disconnect the A solenoid coil sub-assembly connector.
(b) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
Tester Connection | Switch Condition | Specified Condition |
2 - Body ground |
Ignition switch ON |
Below 1 V |
Text in Illustration
*a |
Component without harness connected
(Solenoid Coil Sub-assembly) |
| OK |
 |
REPLACE TRANSFER SHIFT ACTUATOR ASSEMBLY |
| NG |
 |
REPLACE SOLENOID COIL SUB-ASSEMBLY |
|
Was this page helpful?