Engine, Hybrid System
Transfer Synchronization Actuator Circuit Open (P17A5,P17A6)
Done 0 of 12
DESCRIPTION
This DTC is detected when an open circuit or short to ground is detected in the solenoid coil drive circuit.
WIRING DIAGRAM
PROCEDURE
CHECK HARNESS AND CONNECTOR (4 WHEEL DRIVE CONTROL ECU - TRANSFER SHIFT ACTUATOR ASSEMBLY)
(a) Disconnect the A26 4 wheel drive control ECU connector.
(b) Disconnect the D67 transfer shift actuator assembly connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection | Condition | Specified Condition |
A26-6 (SCC) - D67-3 (SCC) |
Always |
Below 1 Ω |
A26-6 (SCC) or D67-3 (SCC) - Body ground |
Always |
10 kΩ or higher |
| NG |
 |
REPAIR OR REPLACE HARNESS OR CONNECTOR |
| OK |
 |
|
INSPECT TRANSFER SHIFT ACTUATOR ASSEMBLY (SCC TERMINAL)
(a) Disconnect the D67 transfer shift actuator assembly connector.
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance: DTC P17A5 is output
Tester Connection | Condition | Specified Condition |
3 (SCC) - Body ground |
Always |
Below 5 Ω |
DTC P17A6 is output
Tester Connection | Condition | Specified Condition |
3 (SCC) - Body ground |
Always |
1 Ω or higher |
Text in Illustration
*a |
Component without harness connected
(Transfer Shift Actuator Assembly) |
| OK |
 |
REPLACE 4 WHEEL DRIVE CONTROL ECU |
| NG |
 |
|
INSPECT SOLENOID COIL SUB-ASSEMBLY
(a) Disconnect the A solenoid coil sub-assembly connector.
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance: DTC P17A5 is output
Tester Connection | Condition | Specified Condition |
2 - Body ground |
Always |
Below 5 Ω |
DTC P17A6 is output
Tester Connection | Condition | Specified Condition |
2 - Body ground |
Always |
1 Ω or higher |
Text in Illustration
*a |
Component without harness connected
(Solenoid Coil Sub-assembly) |
| OK |
 |
REPLACE TRANSFER SHIFT ACTUATOR ASSEMBLY |
| NG |
 |
REPLACE SOLENOID COIL SUB-ASSEMBLY |
|
Was this page helpful?