Rocker Arm Cover and Gasket

GENERAL INFORMATION

Crankcase Breather Hose

Rocker Arm Cover and Gasket

Rocker Arm Cover Gasket and O-Ring Installation

Rocker Arm Cover Installation

Remove or disconnect:

PROCEDURE.

1. Disconnect ventilation hoses C and B from the fittings on the rocker arm cover,

throttle body and air cleaner duct (see figure. Air cleaner duct and electrical connectors).

2. Clamp 179, crankcase breather hose 180 from the rocker arm cover

7..

3. Unscrew four bolts 8 and remove spark plug cover 1 from the rocker arm cover.

rocker arm cover..

4. Spark plug boots, then unscrew bolts 9, cover 7 and gasket

15..

Sealing surfaces of rocker arm cover and cylinder head..

Installation

PROCEDURE.

1. Check that O-rings A are correctly installed in the spark plug holes.

spark plug holes..

2. Install gasket on the rocker arm cover..

Warning.

Check that the semicircular rubber seal is correctly installed in the groove of the ignition distributor housing.

ignition distributor housing seal..

3. Install cover 7 with gasket 15 onto the cylinder head, screw in bolts

9. Tighten the bolts.

rocker arm cover bolts to 8 N·m..

4. Install spark plug boots and high-voltage wires onto the spark plugs (observing the order).

operation of cylinders)..

5. Install spark plug cover 1 and tighten the bolts.

8..

6. Connect crankcase ventilation hose 180 to cover 7 and tighten the clamp.

179..

7. Connect ventilation hoses C and B to the nipples on the valve cover and housing.

throttle valve and air cleaner duct (see illustration). Nipple.

air cleaner and electrical connectors).