Fog Light Bulb Replacement (on some models)

Halogen bulbs are used in the vehicle's headlamps. When replacing a burned-out bulb, hold the new bulb only by its plastic base, do not touch the glass envelope with your fingers, and protect it from contact with hard objects. If fingerprints or grease get on the bulb glass, wipe it with a clean cloth dampened with alcohol.

Halogen bulbs become very hot during operation. Oil, dirt, or scratches on the bulb glass can cause the bulb to overheat and fail quickly.

The fog lights were correctly adjusted when the vehicle was delivered.

However, if you frequently carry heavy loads in the cargo area or tow a trailer, the headlight beam aim may need to be readjusted.

For this procedure, contact an authorized Honda dealer service center.

For vehicles with a gasoline engine

For Diesel Engine Vehicles (Right Side)

1. Using a Phillips screwdriver, remove the mounting bolt and remove the two retainers using a flat-blade screwdriver.

Carefully pull the lower cover out from under the bumper.

For Diesel Engine Vehicles (Left Side)

Using a Phillips screwdriver, remove the screw, then carefully remove the lower rib from the intake duct cover by pressing on it.

2. Disconnect the electrical connector from the bulb.

To do this, squeeze the connector to release the tabs. Then pull the connector off the bulb.

Turn the bulb one-quarter turn counterclockwise and remove it.

3. Install the new bulb and turn it one-quarter turn clockwise to lock the bulb in position.

4. Connect the electrical connector to the bulb. Make sure the connector is fully inserted.

5. Turn on the fog lights to check that the new bulb works.

6. For Gasoline Engine Vehicles / For Diesel Engine Vehicles (Right Side): Install the lower cover and the two retainers, then tighten the mounting bolt securely.

For Diesel Engine Vehicles (Left Side)

Install the rib and tighten the screw securely.