Installation

PROCEDURE

1. Install the vacuum brake booster with a new gasket on the engine compartment partition and secure it with four nuts.
Tightening torque: 8–12 N•m
2. Connect the rod to the brake pedal, install the clevis pin with head and cotter pin hole, and secure it with a new spring cotter pin.
3. Install the brake master cylinder on the vacuum brake booster and secure it with nuts.
4. From the engine compartment, connect the vacuum hose to the vacuum brake booster.
5. Connect the brake tubes and tighten the tube flare nuts.
6. Fill the brake fluid reservoir with brake fluid. Bleed air from the brake hydraulic circuit.
7. Check for brake fluid leaks.
8. Check and, if necessary, adjust the brake pedal height and brake pedal free play.

9. After installation, apply grease to the contact points of the brake pedal and rod.