Maintenance operations - engine oil level inspection, engine oil replacement

ENGINE OIL LEVEL INSPECTION

1. Park the vehicle on a level, horizontal surface.

2. Warm up the engine.

If the vehicle has been parked for a long time, warm up the engine for approximately 20 minutes.

3. Stop the engine, wait 2 - 3 minutes, and then check the engine oil level.

4. Check that the engine oil level is within the allowable range indicated on the engine oil dipstick. If the engine oil level is near or below the minimum level ("L" mark), add oil up to the "F" mark.

Use engine oil of the same type as the oil already in the engine.

5. Check that the engine oil is not contaminated, and that there is no coolant or gasoline in the oil. Check that the engine oil has the correct viscosity.

ENGINE OIL REPLACEMENT

Be careful not to get burned, as the engine oil is hot.

1. Start the engine and warm it up to operating temperature.

2. Turn the engine off.

3. Remove the oil filler cap and loosen the oil pan drain plug. Drain the engine oil.

4. Install and tighten the drain plug to the specified tightening torque.

Tightening torque Drain plug: 35 - 45 N·m 5. Fill the engine with fresh engine oil through the oil filler neck.

Oil capacity Without oil filter replacement: 3.7 L With oil filter replacement: 4 L

Do not fill the engine with engine oil above the maximum level. This will cause oil aeration and reduce oil pressure.

6. Install the oil filler cap.

7. Start the engine and let it run.

8. Turn the engine off and check the engine oil level. Add oil if necessary.