Kia Stinger CK Quiz
Automatic Transmission System

Electronic Module

In this manual: Automatic Transmission System
General Information — 8Maintenance — 27Engine Mechanical System — 47Engine Electrical System — 19Emission Control System — 12Engine Control System/Fuel System — 51Automatic Transmission System — 34All-Wheel Drive (AWD) System — 7Drive Shaft and Axle — 15Suspension System — 25Steering — 8Restraints — 19Brake System — 22Body (Interior and Exterior) — 47Front Seat Belt — 63Body Electrical System — 99Windshield Wiper/Washer — 11Heating, Ventilation, and Air Conditioning — 32
8steps
~48min
2/5difficulty
0102030405024.518N·mlb·ft
Tightening torque found on this page
Done 0 of 8

Components and Component Location

Components

1. Electronic Module Connector
2. Output Speed Sensor
3. Input Speed Sensor		 4. Transmission Fluid Temperature Sensor
5. Shift Solenoid Valve Connector (Indirect Control)
6. Shift Solenoid Valve Connector (Direct Control)

Repair Procedures

Removal

  1. Remove the under cover.

    (Refer to Engine Mechanical System - "Under Hood Compartment").

  2. Remove the ATF drain plug (A), allow the fluid to drain, and then reinstall the drain plug.

    Tightening torque: 22.6–24 N·m

  3. Disconnect the main connector (A).

  4. Remove the valve body cover.

    1. Loosen all valve body bolts except the bolts (A) at the corner.

      Tightening torque: 13.7 - 15.7 N·m

    2. Loosen the two bolts (A) at the corner. After supporting the valve body cover with a jack, remove the valve body cover by lowering the jack slowly.

  5. Remove the valve body (A) after loosening the bolts.

    Tightening Torque: 9.8–11.8 N·m

  6. Remove the electronic module (A) after loosening the bolts.

    Tightening Torque: 9.8–11.8 N·m

Installation

  1. Install in the reverse order of removal.

  2. Fill the automatic transmission with fluid.

    (Refer to Hydraulic System - "Fluid")

Test yourself

A quick Kia Stinger CK quiz: every answer comes with an explanation and a link to the manual page.