Kia Stinger CK Quiz
Automatic Transmission System

E-Shifter

In this manual: Automatic Transmission System
General Information — 8Maintenance — 27Engine Mechanical System — 47Engine Electrical System — 19Emission Control System — 12Engine Control System/Fuel System — 51Automatic Transmission System — 34All-Wheel Drive (AWD) System — 7Drive Shaft and Axle — 15Suspension System — 25Steering — 8Restraints — 19Brake System — 22Body (Interior and Exterior) — 47Front Seat Belt — 63Body Electrical System — 99Windshield Wiper/Washer — 11Heating, Ventilation, and Air Conditioning — 32
11steps
~66min
3/5difficulty
0102030405013.710N·mlb·ft
Tightening torque found on this page
Done 0 of 11

Components and Component Location

Components

1. Electronic Shift Switch
2. Park Release Actuator		 3. Park Lock Cable
4. Park Release Lever

Circuit Diagrams

Wiring Diagram

Description and Operation

Description

  • Operation: Any change in the position of the shift lever is detected and transmitted as electrical signals from the E-Shifter ECM to the TCM.

  • Function

  • Shift Signal Transmission

  • Gear Selector Lever Display

  • Shift Lock

  • System Failure Diagnosis

  • E-Shifter Operation Diagram

  • Operating Procedure

    Flow Diagram

  1. The lever position is detected, and the data is sent to the E-Shifter ECM.

  2. Lever position information is transmitted from the E-Shifter ECM to the TCM (CAN + hard wire).

  3. The TCM controls the AT so that the range reflects the lever position.

  4. The TCM checks the AT final shift range information.

  5. The TCM sends the final shift range information to the E-Shifter ECM. (OPTIONAL)

  6. The E-Shifter ECM sends the final shift range information to the indicator.

  7. The current final shift range information is displayed on the indicator.

Repair Procedures

Removal

  1. Remove the console upper cover (A) using a remover.

  2. Disconnect the main connector (A).

  3. Loosen the E-Shifter fixing screws (A).

  4. Loosen the E-Shifter mounting bolts (A).

    Tightening torque: 8.8–13.7 N·m

Installation

  1. Install in the reverse order of removal.

Test yourself

A quick Kia Stinger CK quiz: every answer comes with an explanation and a link to the manual page.