Clutch Slave Cylinder

repair procedures

expansion

1. Remove the bolts (A) and nut (B), then remove the cylinder assembly (C). Discard.

   Tightening torque: (A) 14.7~22 N·m (B) 12.7–16.7 N·m

   [Gasoline 1.2]

   

   [Gasoline 1.0 / 1.4]

   

Installation

1. Installation is the reverse of removal.

   Recommended grease: CASMOLY L9508. Quantity: 0.4~0.8 g

   

TEST

1. 1

   Check the release cylinder for leaks.

2. 2

   Inspect the release cylinder dust boot for damage.

INSPECTION

Bleeding the Clutch Release Cylinder

1. 1

   After removing the cap from the clutch release cylinder bleed valve, insert a vinyl tube onto the screw.

2. 2

   Fill the clutch master cylinder with the specified fluid.

   Specified fluid: SAE J1703 (DOT 3 or DOT 4)

3. 3

   Loosen the bleeder plug (A) and depress and release the clutch pedal 10 times.

4. 4

   Tighten the bleeder screw (A) while holding the clutch pedal depressed. Then release the pedal.

5. 5

   After depressing the clutch pedal 3 more times, loosen the bleeder screw (A) and tighten it again while holding the pedal down. Then release the pedal.

   Tightening torque: 6.8~9.8 N·m

6. 6

   Repeat step 4 two or three times.

   (Until no more air bubbles appear in the fluid)

   [Gasoline 1.2]

   

   [Gasoline 1.0, 1.4]

   

7. 7

   Fill the brake fluid reservoir with the specified brake fluid.