Kia Stonic Quiz
Clutch System

Clutch Switch

In this manual: Clutch System
General Information — 8Maintenance — 31Engine Mechanical — 49Engine Electrical — 15Emission control system — 11Engine Control System/Fuel System — 45Clutch System — 12Manual Transaxle System — 11DCT (Dual Clutch Transmission) System — 16Drive Shafts and Axles — 9Suspension — 16Steering — 10restraint system — 15Braking system — 22Body (Interior and Exterior) — 89Rear Seat — 16Electrical System — 25Electrochromic Interior Rear View Mirror — 64Heating, Ventilation, and Air Conditioning — 31
9steps
~54min
2/5difficulty
010203040503.93N·mlb·ft
Tightening torque found on this page
Done 0 of 9

Specifications

Specifications

Position Specifications
Operating voltage 12.5 V DC
Operation Free position: 0.25 ± 0.15 N (0.025 ± 0.015 kgf)
Full operation position: 0.8 ± 0.2 N (0.08 ± 0.02 kgf)
Operating temperature -40 °C to 80 °C

Description and Operation

Description

  • Clutch operation is monitored by the clutch switch signal. This signal allows the ECM to instantly change the control to suit the load condition.

  • The clutch switch signal is used to correlate the engaged gear with vehicle speed and engine speed.

repair procedures

TEST

COMPONENT INSPECTION

  1. Remove the clutch and the ignition lock.

  2. Turn the switch lever in the direction of the arrow to check continuity.

expansion

  1. Turn the ignition switch OFF and disconnect the negative (-) battery cable.

  2. Disconnect the ignition switch connector (A).

  3. Remove the clutch switch (B).

Installation

  1. Fully depress the clutch pedal (B).

  2. After installing the bolts that secure the clutch pedal hook to the shift lever, the bolts should move easily.

  3. Turn the switch lever to the ON/OFF position and tighten the screws (A) to the specified torque.

    Tightening torque: 2.0–3.9 N·m

  4. Disconnect the clutch switch connector (A).

Test yourself

A quick Kia Stonic quiz: every answer comes with an explanation and a link to the manual page.