P0504 ASCD brake SWI
DTC Logic
DTC DETECTION LOGIC

Diagnosis Procedure
1.CHECK GROUND CONNECTIONS 1. Turn ignition switch OFF and wait at least 20 seconds.2. Check ground connection E38. Refer to Ground inspection in GI-44, "Circuit Inspection".
Is the inspection result normal? YES >> GO TO 2.
NO >> Repair or replace ground connection.
2.CHECK ASCD BRAKE SWITCH POWER SUPPLY CIRCUIT 1. Disconnect ACSD brake switch harness connector.2. Check the voltage between ACSD brake switch harness connector and ground.

Is the inspection result normal? YES >> GO TO 3.
NO >> Repair open circuit or short to ground or short to power in harness or connectors.
3.CHECK ASCD BRAKE SWITCH INPUT SIGNAL CIRCUIT FOR OPEN AND SHORT1. Check the continuity between ACSD brake switch harness connector and ECM harness connector.

2. Also check harness for short to ground and short to power.
Is the inspection result normal? YES >> GO TO 4.
NO >> Repair open circuit or short to ground or short to power in harness or connectors.
4.CHECK ASCD BRAKE SWITCHRefer to EC-957, "Component Inspection".
Is the inspection result normal? YES >> GO TO 5.
NO >> Replace ASCD brake switch.
5.CHECK INTERMITTENT INCIDENTRefer to GI-42, "Intermittent Incident".
Is the inspection result normal? YES >> Replace ACSD brake switch.
NO >> Repair or replace.
Component Inspection
1.CHECK ASCD BRAKE SWITCH-I 1. Turn ignition switch OFF. 2. Disconnect ASCD brake switch harness connector.3. Check the continuity between ASCD brake switch terminals under the following condition.

Is the inspection result normal? YES >> INSPECTION END
NO >> Replace ASCD brake switch.