Engine Control System K9K
P2002 diesel particulate filter
In this manual: Engine Control System K9K
~1min read
DTC Logic
DTC DETECTION LOGIC

Diagnosis Procedure
1.CHECK DIESEL PARTICULATE FILTERRefer to EC-995, "Component Inspection".
OK or NG OK >> INSPECTION END
NG >> GO TO 2.
2.REPLACE DIESEL PARTICULATE FILTER 1. Replace diesel particulate filter.2. Perform ???Diesel Particulate Filter Data Clear???. Refer to EC-884, "Work Procedure" >> INSPECTION END
Component Inspection
1.CHECK DIESEL PARTICULATE FILTER-I 1. Start engine and warm it up to normal operating temperature. 2. With engine running in neutral position, make 4 accelerations (wait at least 10 seconds between 2 accelerations). 3. Put white duster on exhaust line output. 4. With engine running in neutral position, make 1 acceleration.5. Duster is still white.
Is the inspection result normal? YES >> INSPECTION END
NO >> GO TO 2.
2.CHECK DIESEL PARTICULATE FILTER-II 1. Put a new white duster. 2. With engine running in neutral position, make 10 accelerations.3. Compare duster state with the first one (Step 1 - 5). If duster becames dark grey or black, diesel particulate filter is damaged.
Is the diesel particulate filter damaged? YES >> GO TO 3.
NO >> INSPECTION END
3.REPLACE DIESEL PARTICULATE FILTER 1. Replace diesel particulate filter.2. Perform ???Diesel Particulate Filter Data Clear???. Refer to EC-884, "Work Procedure".
>> INSPECTION END
Was this page helpful?