P0657 ECM relay
DTC Logic
DTC DETECTION LOGIC

NOTE
:
When IPDM E/R DTC is indicated with DTC P0657, IPDM E/R DTC must be checked first.
Diagnosis Procedure
1.CHECK GROUND CONNECTION 1. Turn ignition switch OFF.2. Check ground connection E38. Refer to Ground Inspection in GI-44, "Circuit Inspection".
Is the inspection result normal? YES >> GO TO 2.
NO >> Repair or replace ground connection.
2.CHECK ECM RELAY CIRCUIT-ICheck the voltage between ECM harness connector and ground.

Is the inspection result normal? YES >> GO TO 6.
NO >> GO TO 3.
3.CHECK ECM RELAY CIRCUIT-II 1. Disconnect ECM harness connector F57. 2. Disconnect IPDM E/R harness connector E14.3. Check the continuity between ECM harness connector and IPDM E/R harness connector.

4. Also check harness for short to ground and short to power.
Is the inspection result normal? YES >> GO TO 5.
NO >> GO TO 4.
4.DETECT MALFUNCTIONING PARTCheck the following.
• Harness or connectors E8, F1 • Harness for open or short between ECM and IPDM E/R
>> Repair open circuit or short to ground or short to power in harness or connectors.
5.CHECK 20A FUSE 1. Disconnect 20A fuse (No. 43) from IPDM E/R.2. Check 20A fuse.
Is the inspection result normal? YES >> GO TO 6.
NO >> Replace 20A fuse.
6.CHECK INTERMITTENT INCIDENTRefer to GI-42, "Intermittent Incident".
>> INSPECTION END