P1544 EGT sensor 2
DTC Logic
DTC DETECTION LOGIC

NOTE
:
If DTC P1544 is displayed with DTC P0115, first perform trouble diagnosis for DTC P0115. Refer to EC-907, "DTC Logic".
Diagnosis Procedure
1.CHECK GROUND CONNECTIONS 1. Turn ignition switch OFF.2. Check ground connection E38. Refer to Ground inspection in GI-44, "Circuit Inspection".
Is the inspection result normal? YES >> GO TO 2.
NO >> Repair or replace ground connection.
2.CHECK EXHAUST GAS TEMPERATURE SENSOR 2 POWER SUPPLY CIRCUIT 1. Disconnect exhaust gas temperature sensor 2 harness connector. 2. Turn ignition switch ON.3. Check the voltage between exhaust gas temperature sensor 2 harness connector and ground.

Is the inspection result normal? YES >> GO TO 3.
NO >> Repair open circuit or short to ground or short to power in harness or connectors.
3.CHECK EXHAUST GAS TEMPERATURE SENSOR 2 GROUND CIRCUIT FOR OPEN AND SHORT 1. Turn ignition switch OFF. 2. Disconnect ECM harness connector.3. Check the continuity between exhaust gas temperature sensor 2 harness connector and ECM harness connector.

4. Also check harness for short to ground and short to power.
Is the inspection result normal? YES >> GO TO 4.
NO >> Repair open circuit or short to ground or short to power in harness or connectors.
4.CHECK INTERMITTENT INCIDENTRefer to GI-42, "Intermittent Incident".
Is the inspection result normal? YES >> Replace exhaust gas temperature sensor 2.
NO >> Repair or replace.