P2100 electric throttle control function
DTC Logic
DTC DETECTION LOGIC

Diagnosis Procedure
1.CHECK GROUND CONNECTION 1. Turn ignition switch OFF and wait at least 4 minutes.2. Check ground connection E38. Refer to Ground inspection in GI-44, "Circuit Inspection".
Is the inspection result normal? YES >> GO TO 2.
NO >> Repair or replace ground connection.
2.CHECK THROTTLE CONTROL MOTOR CIRCUIT FOR OPEN AND SHORT 1. Disconnect electric throttle control actuator harness connector. 2. Disconnect ECM harness connectors.3. Check the continuity between the following terminals.

4. Also check harness for short to ground and short to power.
Is the inspection result normal? YES >> GO TO 3.
NO >> Repair open circuit, short to ground or short to power in harness or connectors.
3.CHECK THROTRTLE CONTROL MOTORPerform EC-998, "Component Inspection".
Is the inspection result normal? YES >> GO TO 5.
NO >> GO TO 4.
4.REPLACE ELECTRIC THROTTLE CONTROL ACTUATOR 1. Replace electric throttle control actuator.2. Perform EC-998, "Special Repair Requirement".
>> INSPECTION END
5.CHECK INTERMITTENT INCIDENTRefer to GI-42, "Intermittent Incident".
>> INSPECTION END
Component Inspection
1.CHECK THROTTLE CONTROL MOTOR 1. Reconnect all harness connectors disconnected.2. Check the voltage between ECM harness connectors terminals under the following conditions.

Is the inspection result normal? YES >> INSPECTION END
NO >> GO TO 2.
2.REPLACE ELECTRIC THROTTLE CONTROL ACTUATOR 1. Replace electric throttle control actuator.2. Perform EC-998, "Special Repair Requirement".
>> INSPECTION END
Special Repair Requirement
1.PERFORM THROTTLE VALVE CLOSED POSITION LEARNINGRefer to EC-882, "Work Procedure".
>> END