P0560 battery voltage
DTC Logic
DTC DETECTION LOGIC

NOTE
:
When IPDM E/R DTC is indicated with DTC P0560, IPDM E/R DTC must be checked first.
Diagnosis Procedure
1.CHECK BATTERY VOLTAGE 1. Turn ignition switch ON.2. Check battery voltage.
Voltage: Above 11 V
Is the inspection result normal? YES >> GO TO 2.
NO >> Recharge the battery.
2.CHECK BATTERY TERMINALS 1. Turn ignition switch OFF.2. Check battery terminals condition.
Is the inspection result normal? YES >> GO TO 3.
NO >> Repair the battery terminals.
3.CHECK BATTERY AND ALTERNATORCheck that the proper type of battery and type of alternator are installed.
Refer to, PG-126, "Battery" and CHG-35, "Alternator".
Is the inspection result normal? YES >> GO TO 4.
NO >> Replace with a proper one.
4.CHECK ECM POWER SUPPLY CIRCUIT-ICheck the voltage between ECM harness connector and ground.

Is the inspection result normal? YES >> GO TO 8.
NO >> GO TO 5.
5.CHECK ECM POWER SUPPLY CIRCUIT-II 1. Disconnect ECM harness connector. 2. Disconnect IPDM E/R harness connector E14.3. Check the continuity between ECM harness connector and IPDM E/R harness connector

4. Also check harness for short to ground and short to power.
Is the inspection result normal? YES >> GO TO 7.
NO >> GO TO 6.
6.DETECT MALFUNCTIONING PARTCheck the following.
• Harness connectors E8, F1 • Harness for open or short between ECM and IPDM E/R
>> Repair open circuit or short to ground or short to power in harness or connectors.
7.CHECK 20A FUSE 1. Disconnect 20A fuse (No. 43) from IPDM E/R.2. Check 20A fuse.
Is the inspection result normal? YES >> GO TO 8.
NO >> Replace 20A fuse.
8.CHECK INTERMITTENT INCIDENTRefer to GI-42, "Intermittent Incident", ???INCIDENT SIMULATION TESTS??? and ???GROUND INSPECTION???.
Is the inspection result normal? YES >> Replace IPDM E/R.
NO >> Repair or replace.