Speed limiter main switch
Component Function Check
1.CHECK SPEED LIMITER MAIN SWITCH FUNCTION 1. Turn ignition switch ON.2. Check the voltage between ECM harness connector terminals under the following conditions

Is the inspection result normal? YES >> INSPECTION END
NO >> Go to EC-1020, "Diagnosis Procedure".
Diagnosis Procedure
1.CHECK GROUND CONNECTION 1. Turn ignition switch OFF.2. Check ground connection E38. Refer to Ground Inspection in GI-44, "Circuit Inspection".
Is the inspection result normal? YES >> GO TO 2.
NO >> Repair or replace ground connection.
2.CHECK SPEED LIMITER MAIN SWITCH POWER SUPPLY CIRCUIT 1. Turn ignition switch OFF. 2. Disconnect combination switch (spiral cable) harness connector. 3. Turn ignition switch ON.4. Check voltage between combination switch (spiral cable) harness connector and ground.

Is the inspection result normal? YES >> GO TO 4.
NO >> GO TO 3.
3.DETECT MALFUNCTIONING PARTCheck the following.
• Combination switch (spiral cable) • 10 A fuse (No. 2)
• Harness for open and short between combination switch (spiral cable) and ground.
>> Repair open circuit, short to ground or short to power in harness or connectors.
4.CHECK SPEED LIMITER MAIN SWITCH INPUT SIGNAL CIRCUIT FOR OPEN AND SHORT 1. Turn ignition switch OFF. 2. Disconnect ECM harness connector.3. Check the continuity between ECM harness connector and combination switch (spiral cable) harness connector.

4. Also check harness for short to ground and short to power.
Is the inspection result normal? YES >> GO TO 6.
NO >> GO TO 5.
5.DETECT MALFUNCTIONING PARTCheck the following.
• Harness connector E105, M77 • Combination switch (spiral cable) • Harness for open and short between ECM and combination switch (spiral cable)
>> Repair open circuit, short to ground or short to power in harness or connectors.
6.CHECK ASCD STEERING SWITCHRefer to EC-1021, "Component Inspection".
Is the inspection result normal? YES >> GO TO 7.
NO >> Replace ASCD steering switch.
7.CHECK INTERMITTENT INCIDENTRefer to GI-42, "Intermittent Incident", ???INCIDENT SIMULATION TESTS??? and ???GROUND INSPECTION???.
>> INSPECTION END
Component Inspection
1.CHECK ASCD STEERING SWITCH-I 1. Turn ignition switch OFF. 2. Disconnect combination switch (spiral cable) harness connector.3. Check the continuity between combination switch (spiral cable) harness connector terminals under the following condition.

Is the inspection result normal? YES >> GO TO 2.
NO >> Replace ASCD steering switch.
2.CHECK ASCD STEERING SWITCH-IICheck resistance between combination switch (spiral cable) harness connector terminals under the following conditions.

Is the inspection result normal? YES >> INSPECTION END
NO >> Replace ASCD steering switch.