P1650 thermoplunger control unit
DTC Logic
DTC DETECTION LOGIC

Diagnosis Procedure
1.CHECK THERMOPLUNGER CONTROL UNIT POWER SUPPLY CIRCUIT 1. Turn ignition switch OFF. 2. Disconnect thermoplunger control unit harness connector.3. Check the voltage between thermoplunger control unit harness connector and ground.

Is the inspection result normal? YES >> GO TO 3.
NO >> GO TO 2.
2.DETECT MALFUNCTIONING PARTCheck the following.
• 100A fusible link (letter B) • Harness for open and short between thermoplunger control unit and battery
>> Repair open circuit or short to ground or short to power in harness or connectors.
3.CHECK THERMOPLUNGER CONTROL UNIT SIGNAL CIRCUIT FOR OPEN AND SHORT-I 1. Disconnect ECM harness connector.2. Check the continuity between thermoplunger control unit harness connector and ECM harness connector.

3. Also check harness for short to ground and short to power.
Is the inspection result normal? YES >> GO TO 5.
NO >> GO TO 4.
4.DETECT MALFUNCTIONING PARTCheck the following.
• Harness for open or short between thermoplunger control unit and ECM.
>> Repair open circuit or short to ground or short to power in harness or connectors.
5.CHECK THERMOPLUNGER CONTROL UNIT SIGNAL CIRCUIT FOR OPEN AND SHORT-II 1. Disconnect thermoplunger harness connector.2. Check the continuity between thermoplunger control unit harness connector and thermoplunger harness connector.

3. Also check harness for short to ground and short to power.
Is the inspection result normal? YES >> GO TO 6.
NO >> Repair open circuit or short to ground or short to power in harness or connectors.
6.CHECK THERMOPLUNGERRefer to EC-994, "Component Inspection".
Is the inspection result normal? YES >> GO TO 7.
NO >> Replace malfunctioning Thermoplunger.
7.CHECK INTERMITTENT INCIDENTRefer to GI-42, "Intermittent Incident".
Is the inspection result normal? YES >> Replace thermoplunger control unit.
NO >> Repair or replace.
Component Inspection
1.CHECK THERMOPLUNGER 1. Turn ignition switch OFF. 2. Disconnect thermoplunger harness connector.3. Check resistance between thermoplunger terminals as follows.

Is the inspection result normal? YES >> INSPECTION END
NO >> Replace malfunctioning thermoplunger.