Brakes
Brake Light Switch
In this manual: Brakes
~1min read
GENERAL INFORMATION
The switch plunger is driven by a ratchet.The switch is self-adjusting. To set the switch fully, extend the plunger.
Removal
PROCEDURE
1. Disconnect the battery ground cable.
2. Remove the lower panel on the driver's side.
3. Remove the lower panel on the driver's side.
Installation
PROCEDURE
Extend the plunger and install the switch in the reverse order of removal.Test yourself
A quick Nissan Sunny quiz: every answer comes with an explanation and a link to the manual page.
Was this page helpful?