Hyundai Sonata LF Quiz
Engine Control System/Fuel System

Crankshaft Position Sensor (CKPS) Repair Procedures

In this manual: Engine Control System/Fuel System
General Information — 9Engine Mechanical System — 90Engine Electrical System — 58Emission Control System — 24Engine Control System/Fuel System — 114Drive Shaft and Axle — 15Suspension System — 35Steering — 19Restraints — 50Brake System — 54Body (Interior and Exterior) — 213Body Electrical System — 241Heating, Ventilation, and Air Conditioning — 56DCT (Dual Clutch Transmission) System — 52
2steps
~12min
1/5difficulty
0102030405011.89N·mlb·ft
Tightening torque found on this page
Done 0 of 2

Inspection

  1. Check the CKPS and CMPS signal waveform using the GDS.

    Specification: Refer to "Waveform"

Removal

  1. Turn the ignition switch OFF and disconnect the negative (-) battery cable.
  2. Disconnect the crankshaft position sensor connector (A) and remove the sensor (B) by loosening the mounting bolt.

Installation
  • Install the component with the specified torque.
  • Be aware that internal damage may occur if the component is dropped. If the component has been dropped, inspect it before installation.
  • Apply engine oil to the O-ring.
  • Insert the sensor into the installation hole, being careful not to damage it.
  1. Install in the reverse order of removal. Crankshaft Position Sensor Mounting Bolt: 7.8 ~ 11.8 N·m

Test yourself

A quick Hyundai Sonata LF quiz: every answer comes with an explanation and a link to the manual page.