Hyundai Sonata LF Quiz
Engine Control System/Fuel System

Repair Procedures - CVVT Oil Control Valve (OCV)

In this manual: Engine Control System/Fuel System
General Information — 9Engine Mechanical System — 90Engine Electrical System — 58Emission Control System — 24Engine Control System/Fuel System — 114Drive Shaft and Axle — 15Suspension System — 35Steering — 19Restraints — 50Brake System — 54Body (Interior and Exterior) — 213Body Electrical System — 241Heating, Ventilation, and Air Conditioning — 56DCT (Dual Clutch Transmission) System — 52
7steps
~42min
2/5difficulty
0102030405011.89N·mlb·ft
Tightening torque found on this page
Done 0 of 7

Inspection

  1. Turn the ignition off.
  2. Disconnect the OCV connector.
  3. Measure the resistance between terminals 1 and 2 of the OCV.
  4. Make sure the resistance is within specification.

    Specification: Refer to "Specifications"

Removal

  1. Turn the ignition switch OFF and disconnect the negative (-) battery cable.
  2. Disconnect the CVVT oil control valve connector (A).
  3. Loosen the installation bolt (B) and remove the valve from the engine. [Bank 1 / Intake]
    [Bank 1/Exhaust]

Installation
  • Install the component with the specified torque.
  • Note that internal damage may occur if the component is dropped. If the component has been dropped, inspect it before installation.
  • Apply engine oil to the O-ring of the valve.
  1. Install in the reverse order of removal. CVVT oil control valve bolt: 9.8 ~ 11.8 N·m

Test yourself

A quick Hyundai Sonata LF quiz: every answer comes with an explanation and a link to the manual page.