Hyundai Sonata LF Quiz
Engine Control System/Fuel System

Repair Procedures - Purge Control Solenoid Valve (PCSV)

In this manual: Engine Control System/Fuel System
General Information — 9Engine Mechanical System — 90Engine Electrical System — 58Emission Control System — 24Engine Control System/Fuel System — 114Drive Shaft and Axle — 15Suspension System — 35Steering — 19Restraints — 50Brake System — 54Body (Interior and Exterior) — 213Body Electrical System — 241Heating, Ventilation, and Air Conditioning — 56DCT (Dual Clutch Transmission) System — 52
8steps
~48min
2/5difficulty
0102030405011.89N·mlb·ft
Tightening torque found on this page
Done 0 of 8

Inspection

  1. Turn the ignition off.
  2. Disconnect the PCSV connector.
  3. Measure the resistance between terminals 1 and 2 of the PCSV.
  4. Make sure the resistance is within specification.

    Specification: Refer to "Specifications"

Removal

  1. Turn the ignition switch OFF and disconnect the negative (-) battery cable.
  2. Disconnect the purge control solenoid valve connector (A).
  3. Disconnect the vapor hoses (B) from the purge control solenoid valve.
  4. Remove the installation bolt (C) and remove the PCSV (D) from the engine.

Installation
  • Install the component with the specified torque.
  • Note that internal damage may occur if the component is dropped. If the component has been dropped, inspect it before installation.
  • Take care not to allow foreign matter to enter the valve.
  1. Install in the reverse order of removal. Purge control solenoid valve bracket bolt: 9.8 ~ 11.8 N·m

Test yourself

A quick Hyundai Sonata LF quiz: every answer comes with an explanation and a link to the manual page.